Lexmark MX310 Fax Station Name not set up. Contact system administrator, Imaging unit low 84.xy

Troubleshooting 184

Fax Station Name not set up. Contact system administrator.

Try either of the following:

•From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models, press

to confirm.

•Complete the Analog Fax Setup. If the message appears again after completing the setup, then contact your system support person.

Fax Station Number not set up. Contact system administrator.

Try either of the following:

•From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models, press

to confirm.

•Complete the Analog Fax Setup. If the message appears again after completing the setup, then contact your system support person.

Imaging unit low [84.xy]

You may need to order an imaging unit. If necessary, select Continue on the printer control panel to clear the message

and continue printing. For non‑touch‑screen printer models, press to confirm.

Imaging unit nearly low [84.xy]

If necessary, select Continue on the printer control panel to clear the message and continue printing. For

non‑touch‑screen printer models, press to confirm.

Imaging unit very low, [x] estimated pages remain [84.xy]

You may need to replace the imaging unit very soon. For more information, see the "Replacing supplies" section of the User’s Guide.

If necessary, select Continue on the printer control panel to clear the message and continue printing. For

non‑touch‑screen printer models, press to confirm.

Incorrect paper size, open [paper source] [34]

Try one or more of the following:

•Load the correct size of paper in the tray.

•From the printer control panel, select Continue to clear the message and print using a different tray. For

non‑touch‑screen printer models, press to confirm.

•Check the tray length and width guides and make sure the paper is loaded properly in the tray.

•Make sure the correct paper size and type are specified in the Printing Preferences or in the Print dialog.