Intermate LX T-04 manual P e n d i c e s

A p p e n d i c e s

2.Make sure the Intermate LX T-04 is attached correctly to the printer. See separate sheet for details about installing the interface.

Note: If the LX T-04 was attached to the system and operating, then the current address switch position represents the device address assigned to the LX T-04. Write this number down and save it.

3.Set the address switch to position “9". This generates a test printout at the next power On.

4.Switch On the printer. The SYSTEM indicator flashes for a few seconds.

5.Study the test printout. It shows the firmware number and the default settings. Note whether the ASCII character set is set to “PC-858", which means Euro Support is active.

******** TEST PRINTOUT ********

Intermate LX T-04 version: K12-8491

Printer Driver #32 IBM Proprinter

IBM Printer Emulation__________ IBM 4214 model 2

System Language________________ 500 International Set 5

ASCII Char. Set________________ PC-858

6.Switch Off the printer.

7.Connect a terminal to the Intermate LX T-04 using the T-cable, and switch the terminal On. The terminal should be terminated.

8.Set the address switch to position “7" and switch On the printer. Wait a few seconds after the SYSTEM indicator has stopped flashing.

9.Select position “9". Wait until the SYSTEM indicator starts to flash.

I n t e r m a t e L X T - 0 4 67