A d v a n c e d F u n c t i o n s
30 U s e r ‘ s G u i d e
Define the Sequences
The parameters are defined when Extended Emulation Mode is entered.
Example:
Enter Extended Emulation Mode and set the Transparency Lead-In Sequence to
'%%', the Configuration Lead-In Sequence to '%P' and the Trailer Sequence to
'%':
&&??%%P
(Enter Extended Emulation Mode and set parameters)
Redefine the Sequences
The parameters can be redefined using text sequences in the document.
Example:
Change the Transparency Lead-In Sequence from '%%' to '!?<' (EBCDIC codes
$4F,$6F,$4C).Also, change the Trailer Sequence from '%' to '>&' (EBCDIC
codes $6E,$50):
%P
(Configuration lead-in sequence)
=41,$4F,$6F,$4C (
New
Transparency Lead-In)
=43,$6E,$50
(New Transparency Lead-Out)
=205
(Save settings permanently)
>&
(Initialize settings)
Note: - To redefine the sequences, Extended Emulation Mode must be
entered. The sequences are reset if you exit and re-enter
Extended Emulation Mode. See above.
- The sequences are redefined immediately. Therefore, the new
sequence '>&' must be used as Configuration Trailer Sequence in
the document.