Invacare TerminatorTM SS manual REMOVING/INSTALLING Rear Wheels Figure, Section Wheels

WHEELS

SECTION 5 WHEELS

Section 5 - Wheels - includes the following:

Removing/Installing Rear Wheels

Adjusting Quick-Release Axles

Installing Quad-Release Axles

Adjusting Quad-Release Handles

Handrim Replacement

Repairing/Replacing Rear Wheel, Tire/Tube

Opening/Closing Clamps

Adjusting Rear Wheel Camber

Determining Toe in/Toe out

Adjusting Toe in/Toe out

Adjusting Wheelbase Length (Adjusting Center of Gravity)

Adjusting Wheelbase Width

Replacing Axle Tube

Adjusting the Axle Tube

Replacing Adjusting Casters

Adjusting Front Caster Height

Wheel Lock Adjustment/Replacement

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

REMOVING/INSTALLING REAR WHEELS (FIGURE 1)

CAUTION

Changing the size of the rear wheels can affect the performance of the wheelchair. Contact Invacare at the telephone numbers on the back of this manual BEFORE changing rear wheel size.

1.Perform one (1) of the following:

QUICK-RELEASE - Push in the tip of the quick-release axle and pull axle and wheel away from the wheelchair.

QUAD-RELEASE - Lift UP on the handle of the quad-release axle and pull axle and wheel away from the wheelchair.

2.Repeat STEP 1 for the opposite rear wheel.

3.Reinstall the rear wheels onto the wheelchair by reversing STEPS 1-2.

Terminator™ SS 26 Part No. 1052712 Rev D