Invacare TerminatorTM SS Repositioning Quick Release Levers Figure, Reverse, Suspension Procedure

SUSPENSION PROCEDURE 7

REPOSITIONING QUICK RELEASE LEVERS (FIGURE 6)

NOTE: This procedure should only be performed if quick release levers are on top of the axle mounting tube and interfere with the desired rear seat-to-floor adjustment. This procedure will position the quick release lever on the bottom of the axle tube.

1.Remove the threaded knob from the quick release lever.

2.Remove the quick release lever, recessed washer and coved washer from the camber clamp.

3.If necessary, position the recessed washer and coved washer onto the quick release lever, as shown in FIGURE 6.

4.Insert the quick release lever with washers through the camber clamp as shown in FIGURE 6.

Quick Release Lever

Recessed Washer

and Coved Washer

Camber Clamp

Threaded

Knob

SIDE VIEW OF CAMBER CLAMP WITH QUICK RELEASE LEVER

REVERSE

POSITIONS

LEVER ON	LEVER ON CLAMP
CLAMP TOP	BOTTOM

FIGURE 6 - REPOSITIONING QUICK RELEASE LEVERS

SUSPENSION

Part No. 1052712 Rev D 57 Terminator™ SS