SECTION 5 | WHEELS |
|
|
ADJUSTING REAR WHEEL CAMBER
CAMBER TUBE 2000
The axle tube must be replaced to change the camber. Refer to REPLACING AXLE TUBE in this section of the manual.
A4 CAMBER SYSTEM (FIGURE 7)
WHEELS
NOTE: Perform this procedure to one (1) side of the wheelchair at a time for ease of adjustment.
1. | Open the camber clamp. Refer to |
| OPENING/CLOSING CLAMPS in this |
| section of the manual. |
2. | Pull one (1) rear wheel with camber |
| insert out of axle tube. |
3. | Remove the rear wheel from the |
| camber insert. |
4. | Rotate the camber insert 180o. |
Rear View of Wheelchair
Camber Insert -
Rotate 180o
Indexing Ring
Indexing Marks
Axle Tube
Camber Clamp
5. Reinstall the rear wheel into the |
camber insert. |
FIGURE 7 - ADJUSTING REAR
WHEEL CAMBER -
A4 CAMBER SYSTEM
WARNING
NEVER position the camber inserts in the axle tube with more than 3- inches (12 indexing marks showing) of the camber insert outside of the axle tube. The camber inserts will not be securely tightened in the axle tube resulting in possible injury to the user and/or damage to the wheelchair.
6.Position the camber insert to the desired position. Make sure there is no more than
7.Slide the indexing ring on the camber insert until it is flush with the camber clamp.
NOTE: Before using the wheelchair, make sure both camber inserts are set to the same indexing mark. This will make sure the distance between the rear wheel and the wheelchair is the same on both sides.
WARNING
QUICK RELEASE LEVERS - Make sure the quick release levers are pointing towards the rear of the wheelchair and are in the CLOSED position BEFORE using the wheelchair, otherwise personal injury or damage to the wheelchair may result.
STANDARD - Make sure the hex screws and locknuts are securely tightened BEFORE using the wheelchair, otherwise personal injury or damage to the wheelchair may result.
8.Close the camber clamp. Refer to OPENING/CLOSING CLAMPS in this section of the manual.
9.Repeat STEPS
Terminator™ SS | 32 | Part No. 1052712 Rev D |
