WHEELS | SECTION 5 |
|
|
RECEIVER TUBE CLAMPS
1.Perform one (1) of the following to open a receiver tube clamp:
A.QUICK RELEASE LEVERS - Pull the quick release levers on the receiver tube clamps to the open position.
B.STANDARD RECEIVER TUBE CLAMPS - Loosen, but do not remove the hex screws and locknuts on the receiver tube clamps.
2.Perform one (1) of the following to close a receiver tube clamp:
A.QUICK RELEASE LEVERS - Tighten the threaded knob to secure the quick release lever. Push the quick release lever on the receiver tube clamps to the closed position.
B.STANDARD RECEIVER TUBE CLAMPS - Tighten the hex screw and locknut on the receiver tube clamp. Torque to 75 in./lbs.
CAMBER CLAMPS
QUICK RELEASE LEVER | STANDARD |
CLOSED 
POSITION
Quick Release | OPEN | Hex Screw | |
Lever | POSITION | ||
and Locknut | |||
| |||
| RECEIVER TUBE CLAMPS | ||
QUICK RELEASE LEVER | STANDARD | ||
CLOSED POSITION
| Quick |
|
| Release Lever |
|
| Hex Screw | Locknut |
|
| |
Threaded Knob | OPEN POSITION |
|
|
| |
| FIGURE 6 - OPENING/CLOSING CLAMPS |
|
WHEELS
Part No. 1052712 Rev D | 31 | Terminator™ SS |
