FOOTREST / ANTI-TIPPER
SECTION 6 |
|
|
|
Section 6 -
Adjusting/Replacing Standard Footrest
Installing/Adjusting Optional Clamp on Raised Footrest
Installing/Adjusting Optional A4 Footrest
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.
ALWAYS perform this procedure in the presence of an assistant. The position of the footrest, camber tube, back angle, the tautness of the back upholstery as well as the user's condition are directly related to the wheelchairs stability. Any change to one (1) or any combination of the five (5) may cause the wheelchair to decrease in stability. Use EXTREME caution when using a new seating position. The addition of
Check ALL allen screws that secure the footrest/raised footrest system to the wheelchair frame to make sure they are securely tightened BEFORE using the wheelchair, ESPECIALLY if engaging in ANY contact sport.
The footrest assembly MUST be at least
ADJUSTING/REPLACING STANDARD FOOTREST (FIGURE 1)
1. Loosen the two (2) allen screws that secure the footrest to the wheelchair frame.
IF REPLACING THE FOOTREST:
1.Remove EXISTING footrest.
2.Install NEW footrest.
WARNING
The standard footrest has an open hoop. A footplate cover is recommended for wheelchair users that have leg spasticity or whose feet have a possibility of falling through the footrest hoop. A calf strap is provided with each wheelchair to prevent the feet from slipping backwards off of the footrest. Be sure the calf strap is secure when using the wheelchair.
Allen Screws
(Not Shown)
Wheelchair
Frame
Footrest
FIGURE 1 - ADJUSTING/REPLACING
STANDARD FOOTREST
IF REPLACING OR ADJUSTING THE FOOTREST:
1.Position NEW/EXISTING footrest to desired height.
2.Tighten the two (2) allen screws that secure the footrest to the wheelchair frame.
Terminator™ SS | 46 | Part No. 1052712 Rev D |
