Invacare TerminatorTM SS manual Adjusting QUICK-RELEASE Axles Figure, Wheels Section

WHEELS SECTION 5

WARNING

Pull on the rear wheel to make sure the detent pin and locking pins of the quick/quad-release axle are fully released BEFORE operating wheelchair.

Keep locking pins clean.

4.If there is too much movement of the rear wheel assembly in a back and forth motion, refer to ADJUSTING QUICK-RELEASE AXLES or ADJUSTING QUAD-RELEASE HANDLES in this section of the manual.

	Locking Pins		Wheelchair
		Quick-Release
			Frame
Detent Pin		Axle
			Rear Wheel

NOTE: Quad-Release Axle not shown. Locking pins the same as Quick-Release Axle.

FIGURE 1 - REMOVING/INSTALLING REAR WHEELS

ADJUSTING QUICK-RELEASE AXLES (FIGURE 2)

1.Remove rear wheel and quick-release axle from the wheelchair. Refer to REMOVING/INSTALLING REAR WHEELS in this section of the manual.

2.Depress detent pin in the quick-release axle and slide axle through the wheel hub.

3.Release detent pin ensuring that the locking pins are fully released.

4.Increase or decrease end play by adjusting the locknut on the end of the quick-release axle.

5.Reinstall rear wheel onto the wheelchair. Refer to REMOVING/INSTALLING REAR WHEELS in this section of the manual.

WHEELS

Adjustable Axle Position

Camber Bar

Locking Pins

NOTE: End of Quick Release axle is shown for reference only. It is not visible when inserted into camber bar

Locknut

Detent Pin

Wheel Hub

Quick Release Axle

FIGURE 2- ADJUSTING QUICK-RELEASE AXLES

Part No. 1052712 Rev D 27 Terminator™ SS