Invacare TerminatorTM SS Wheel Lock ADJUSTMENT/REPLACEMENT Figure, Front, Wheel Lock Adjustment

WHEELS SECTION 5

WHEEL LOCK ADJUSTMENT/REPLACEMENT (FIGURE 21)

NOTE: Invacare recommends LOW mount wheel locks when engaging in any contact sport.

NOTE: Before adjusting or replacing the High/Low mount wheel locks, ensure that the tires are inflated to the recommended psi on the sidewall of the tire.

1.Loosen the locknuts and hex/allen screws that secure the High/Low mount wheel locks to side frame.

2.Perform one (1) of the following:

Replacing the High/Low Mount Wheel Lock:

A.Remove the locknuts and hex/allen screws and remove existing wheel lock from the wheelchair.

B.Install the NEW wheel lock and adjust.

Adjusting the High/Low Mount Wheel Lock:

A.Measure the distance between the WHEEL LOCK SHOE and the REAR WHEEL.

B.Slide the wheel lock along the wheelchair until the measurement is between 5/32 and 5/16-inches.

C.Tighten the wheel lock to the wheelchair frame.

D.Repeat this procedure for the opposite wheel lock.

E.Engage the wheel locks and push against the wheelchair to determine if the wheel locks engage the rear wheels enough to hold the occupied wheelchair.

F.Repeat STEPS A-E until the wheel locks engage the rear wheels enough to hold the occupied wheelchair.

WHEELS

FRONT REAR

Wheelchair Frame

Low Mount

Wheel Lock

Wheel Lock	Hex Screws
Shoe

Wheelchair

WHEEL LOCK ADJUSTMENT

Wheelchair Frame

Wheel	NOTE: High
Lock Shoe
	mount wheel
	lock shown for

High Mount Wheel Lock

Wheel Lock

Shoe

Frame

	clarity.
5/32 to 5/16-inch Gap	Rear Wheel

NOTE: Rear wheel not shown for clarity.

FIGURE 21 - WHEEL LOCK ADJUSTMENT/REPLACEMENT

Part No. 1052712 Rev D 45 Terminator™ SS