WHEELS

PROCEDURE 6

 

 

ADJUSTING (FIGURE 4)

Adjusting Quad-Release Handles In And/Or Out.

1.Remove rear wheel and quad-release axle from the chair, refer to REMOVING/INSTALL- ING THE REAR WHEELS in this procedure of the manual.

2.Loosen the locking screw.

3.Make the following adjustments if necessary:

A.If the quad-release handle is not releasing the locking pins completely, rotate the quad-release handle approximately one-quarter (1/4) turn CLOCKWISE.

B.If the quad-release handle hits the spokes of the rear wheel when assembled, rotate the quad-release handle approximately one-quarter (1/4) turn COUNTERCLOCKWISE.

4.Tighten the locking screw.

5.Reinstall rear wheel and quad-release axle onto the chair.

WARNING

Make sure detent pin of the quad-release axle is fully released BEFORE operat- ing the wheelchair.

Keep locking pins clean.

6.Flip handle of the quad-release axle down to release the detent pin ensuring that the locking pins are fully released.

7.Repeat the above procedures until the quad-release axle locks correctly.

Removing Play From Rear Wheels.

1.With the rear wheel and quad-release axle still mounted onto the chair, make the follow- ing adjustment:

A.Tighten length adjusting screw until there is no in and out movement of quad-release axle and rear wheel.

Quad-Release Handle

Locking Pins

Locking

Camber Insert

Screw

 

ADJUSTING QUAD-RELEASE HANDLE

IN OR OUT

REMOVING PLAY

 

FROM THE REAR

 

WHEELS

Length

Reduces Play

Adjustment

 

 

Screw

FIGURE 4 - ADJUSTING QUAD-RELEASE AXLES

WHEELS

Part No. 1054916

33

T-3™ and T-4™ Series

Page 33
Image 33
Invacare Top End T-3 manual Adjusting Figure, Adjusting Quad-Release Handles In And/Or Out, Removing Play From Rear Wheels