T-3™ and T-4™ Series 40 Part No. 1054916
WARNING
QUICK RELEASE LEVERS - Make sure the quick release levers are pointing
towards the rear of the wheelchair and are in the CLOSED position BEFORE
using the wheelchair, otherwise personal injury or damage to the wheelchair
may result.
STANDARD - Make sure the hex screws and locknuts are securely tightened
BEFORE using the wheelchair, otherwise personal injury or damage to the
wheelchair may result.
13. Make sure the quick release levers or hex screws and locknuts are securely tightened.
FIGURE 10 - ADJUSTING TOE IN/TOE OUT - AXLE TUBE IS MOVEDFROM FACTORY SET POSITION OR IS REPLACED
LOWER DEGREE OF CAMBER
Metal Tab
(STEP 5STEP 5
STEP 5STEP 5
STEP 5)
Frame Bracket
Axle Tube
Set Screw (STEP 2STEP 2
STEP 2STEP 2
STEP 2)
Tab
(STEP 5STEP 5
STEP 5STEP 5
STEP 5)
Toe Adjustment
Ring (STEP 5STEP 5
STEP 5STEP 5
STEP 5)
Axle Tube - Will Rotate UP Only
HIGHER DEGREE OF CAMBER
Toe Adjustment
Ring (STEP 5STEP 5
STEP 5STEP 5
STEP 5)
Axle Tube
Set Screw
(STEP 2STEP 2
STEP 2STEP 2
STEP 2)
Frame Bracket
Tab (STEPSTEP
STEPSTEP
STEP
55
55
5)
Metal Tab
(STEP 5STEP 5
STEP 5STEP 5
STEP 5)
Axle Tube - Will Rotate DOWN Only
WHEELS
PROCEDURE 6 WHEELS