Cooktop
To prevent the cooktop from discoloring or staining:
•Clean cooktop after each use.
•Wipe acidic or sugary spills as soon as the cooktop has cooled as these spills may discolor the
porcelain.
Unlike a range with standard gas burners, 
this cooktop does not
removable. Do not attempt to lift the cooktop for any reason.
Sealed Burners
The sealed burners of your range are secured to the cooktop and are not designed to be removed. Since the burners are sealed into the cooktop, boilovers or spills will not seep underneath the cooktop.
However, the burner should be cleaned after each use. The cap portion of the burner is easily removed for cleaning. (See page 7 for cleaning directions.)
The burner caps must be correctly placed on the burner base for proper operation of the burner.
High Performance
Burner
There is one 16,000 BTU* high speed burner on your range, located in the right front position. This burner offers higher
speed cooking that can be used to quickly
bring water to a boil and for
Simmer/Melt Burner
This burner is located in the right rear position. The SIMMER setting can be used to steam or poach foods, to cook delicate sauces or continue cooking covered foods. The ultra low MELT setting is best for melting chocolate and butter.
Important: When using the normal settings for preparing foods, it may take a few minutes for the cooking area to cool to the MELT heat setting.
* BTU ratings will vary when using LP gas.
Burner Grates
The grates must be properly positioned before cooking. When installing the grates, place the tab ends toward the center, matching the straight bars.
Improper installation of the grates may result in chipping of the cooktop.
Do not operate the burners without a pan on the grate. The grate’s porcelain finish may chip without a pan to absorb the heat from the burner flame.
Use care when stirring food in a pot/pan sitting on the burner grate. The grates have a smooth finish for ease of cleaning. The pot/pan will slide if the handle is not held. This may result in spilling of hot food items and may be a burn hazard.
Although the burner grates are durable, they will gradually lose their shine and/or discolor, due to the high temperatures of the gas flame.
Notes:
•A properly adjusted burner with clean ports will light within a few seconds. If using natural gas, the flame will be blue with a deeper blue inner cone.
If the burner flame is yellow or is noisy, the air/gas mixture may be incorrect. Contact a service technician to adjust. (Adjustments are not covered by the warranty.)
With LP gas, slight yellow tips on the flames are acceptable. This is normal and adjustment is not necessary.
•With some types of gas, you may hear a “popping” sound when the surface burner is turned off. This is a normal operating sound of the burner.
•If the control knob is turned very quickly from HIGH to LOW, the flame may go out, particularly if the burner is cold. If this occurs, turn the knob to the OFF position, wait several seconds and relight the burner.
•The flame should be adjusted so it does not extend beyond the edge of the pan.
13
