EX2500 Ethernet Switch Configuration Guide
Each packet’s particular MAC or IP address information results in selecting one line in the trunk group for data transmission. The more data streams are feeding the trunk lines, the more evenly traffic is distributed.
Built-In Fault Tolerance
Since each trunk group is made up of multiple physical links, the trunk group is inherently fault tolerant. As long as one connection between the switches is available, the trunk remains active.
Statistical load balancing is maintained whenever a port in a trunk group is lost or returned to service.
Before Configuring Static Trunks
When you create and enable a static trunk, the trunk members (switch ports) take on certain settings necessary for correct operation of the trunking feature.
Before you configure your trunk, you must consider these settings, along with specific configuration rules, as follows:
1.Read the configuration rules provided in the section, “Trunk Group Configuration Rules” on page 44.
2.Determine which switch ports (up to 12) are to become trunk members (the specific ports making up the trunk).
Ensure that the chosen switch ports are set to enabled. Trunk member ports must have the same VLAN and Spanning Tree configuration.
3.Consider how the existing Spanning Tree will react to the new trunk configuration. See “Spanning Tree Protocol” on page 31 for Spanning Tree Group configuration guidelines.
4.Consider how existing VLANs will be affected by the addition of a trunk.
Trunk Group Configuration Rules
The trunking feature operates according to specific configuration rules. When creating trunks, consider the following rules that determine how a trunk group reacts in any network topology:
All trunks must originate from one device, and lead to one destination device.
Any physical switch port can belong to only one trunk group.
Trunking from
When ports become members of a trunk, configuration parameters (except ACL and QoS) are applied per trunk. When a trunk group is formed, these parameters are configured for the trunk ID, which overrides the
All trunk member ports must be assigned to the same VLAN configuration before the trunk can be enabled.
44 Trunking Overview
