Connecting to Various Devices (Cont.)
Connecting to Devices which Control the Projector
Before connection, be sure to turn off both the projector and devices to be connected.
•Read the manual thoroughly which comes with each device to be connected.
•By connecting a computer to the
*For details, consult an authorized your dealer or service center.
•If you connect the cable terminal of the remote control and the REMOTE terminal of the projector with a remote control cable, you can use the remote control in a place or at an angle from which the infrared beam cannot reach the projector.
•Desktop type
|
| Y/C | V |
RGB RGB |
|
| |
R | RGB | EXT. IN |
|
To |
|
|
|
G | H/CS |
|
|
B | V |
|
|
|
|
| |
Connecting to Various Devices (Cont.)
Connecting the Power Cord (Supplied)
After all devices have finished being connected, connect the projector’s power cord. At this time, do not turn on the MAIN POWER switch yet.
1 Insert the supplied power cord into the power input terminal (AC IN ~) of the projector.
1. Remove the power input terminal cover.
The cover is a screwed type. Turn the cover in the direction of the arrow to remove.
1
Power cord (supplied)
No.51666
cable (separately available) |
|
REMOTE |
|
RGB OUT | CON |
| |
To |
|
• Note type |
|
To REMOTE terminal |
|
To |
|
2
220V, single phase
CAUTION
To prevent fire and electric shock, observe the following:
• When you do not use devices, pull out their power cords |
from wall outlets. |
• Do not connect the devices with power cords other than |
supplied. |
• Do not use voltage other than the power voltage indicated. |
• Do not scar, damage, or work on the power cords. Also, do |
not put a heavy object on, heat or pull the power cords, |
otherwise they may be damaged. |
2.Insert the projector plug of the supplied power cord into the power input terminal of the projector. Align the groove on the projector plug of the power cord with the claw on the power input terminal of the projector, and push the plug in firmly.
After that, turn the ring on the plug in the direction of the arrow to fix.
• Remote control (when remote control cable is used)
To remote control |
cable terminal |
Remote control cable
• Do not insert or pull out the plugs with a wet hand. |
| 2 Insert the plug of the supplied |
■ To use the projector | power cord into a wall outlet, and |
• Remove the lens cap. | turn the plug to right to fix. |
| CAUTION |
| • Since the power requirement of the projector is high, be sure |
| to insert the power plug directly into a wall outlet. |
Lens cap | • This projector requires a single phase, |
| outlet. |
22 | 23 |
