16 EN GET OVER IT! – CONNECTION –
Connections
It’s essential that your unit be properly connected.
THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.
Connect the unit to a TV depending on the TV and cables you use.
●( pg. 16, “Composite Connection (Without Cable Box Or DBS Receiver)”)
●( pg. 17, “Composite Connection (With Cable Box Or DBS Receiver)”)
●( pg. 18, “Component Video Connection”)
1
2
3
4
Disconnect the antenna from the TV.
Connect the antenna to the [VHF/UHF IN] connector on the rear panel of the unit.
Connect the supplied RF cable between the [VHF/ UHF OUT] connector on the rear panel of the unit and the TV’s antenna terminal.
Connect the supplied audio/video cable between the [VIDEO/AUDIO OUTPUT (DVD/VCR)] connectors on the unit and the TV’s audio/video input connectors.
Composite Connection (Without Cable Box Or DBS Receiver)
Antenna or Cable
Coaxial cable | |
Flat feeder |
|
| Matching transformer |
| (not supplied) |
AC outlet | RF cable (not supplied) |
| |
AC power cord | To [VHF/UHF |
| IN] |
Back of unit | To [VHF/ |
To [VIDEO/ | |
AUDIO | UHF OUT] |
OUTPUT |
|
(DVD/VCR)] |
|
Audio/video cable |
|
(supplied) |
|
To audio/ | RF cable |
video input | (supplied) |
connectors |
|
TV | To 75 ohm |
terminal | |
To component video |
|
input connectors |
|
5 Plug the end of the AC power cord into an AC outlet. This unit performs Plug & Play Set automatically. ( pg. 19)
●The clock and tuner channels will automatically be set when the antenna is connected and when the AC power cord is first connected to an AC outlet. (If “AUTO” and the channel indicator are displayed on the front display panel before the unit is powered on, the clock and tuner channels are being set automatically. Wait for the time to be displayed on the front display panel before turning on the unit.)
●“LOADING” blinks on the front display panel when the AC plug of the AC power cord is connected into an AC outlet and it takes approximately 50 seconds for the unit to be turned on. This is not a malfunction.
NOTE:
You cannot view images received by this unit on channel 3 or 4.
