18 EN GET OVER IT! – CONNECTION –
Component Video Connection
|
| Antenna or Cable |
| Coaxial cable | |
|
| Flat feeder |
| Matching transformer | To [VIDEO/AUDIO INPUT |
| (not supplied) | (DVD/VCR)] |
RF cable (not supplied) |
|
|
| Audio/video |
|
To antenna input | cable | AC outlet |
(not supplied) | ||
connector |
|
|
AC power cord
Back of cable box or DBS receiver
To audio/video | To |
| |
output connectors | [COMPONENT |
| |
To antenna output | VIDEO OUT (Y/ | ||
PB/PR)] | To [VIDEO/ | ||
connector | |||
| AUDIO OUTPUT | ||
|
| ||
|
| (DVD/VCR)] | |
RF cable | To [VHF/UHF IN] | Audio/video cable | |
(supplied) | |||
(not supplied) |
| ||
|
| ||
Component video cable |
|
| |
(not supplied) |
| To audio/video input | |
|
| connectors | |
Back of unit
To [VHF/UHF OUT]
RF cable (supplied)
To 75 ohm terminal
TV
To component video input connector
1
2
3
4
5
6
Disconnect the antenna from the TV.
Connect the antenna to the antenna input connector on the cable box or DBS receiver.
Connect the RF cable between the unit’s [VHF/UHF IN] connector to the antenna output connector on the cable box or DBS receiver.
Connect the supplied RF cable between the [VHF/ UHF OUT] connector on the rear panel of the unit and the TV’s antenna terminal.
Connect the supplied audio/video cable between the [VIDEO/AUDIO OUTPUT (DVD/VCR)] connectors on the unit and the TV’s audio/video input connectors.
Connect the audio/video cable between the [VIDEO/ AUDIO INPUT (DVD/VCR)] connectors on the unit and the audio/video output connectors on the cable box or DBS receiver.
7 Connect the unit’s [COMPONENT VIDEO OUT (Y/ PB/PR)] connectors to the TV’s component video input connectors.
●You can obtain
●If your TV is not
●By using the component video connection, you can view the images in the progressive mode. For switching to the progressive mode, refer to “Scan Mode Set” ( pg. 74).
8 Plug the end of the AC power cord into an AC outlet. This unit performs Plug & Play Set automatically. ( pg. 19)
●The clock and tuner channels will automatically be set when the antenna is connected and when the AC power cord is first connected to an AC outlet. (If “AUTO” and the channel indicator are displayed on the front display panel before the unit is powered on, the clock and tuner channels are being set automatically. Wait for the time to be displayed on the front display panel before turning on the unit.)
●“LOADING” blinks on the front display panel when the AC plug of the AC power cord is connected into an AC outlet and it takes approximately 50 seconds for the unit to be turned on. This is not a malfunction.
NOTE:
When watching the images on the VHS deck with this connection, set to the progressive scan mode. ( pg. 58, “VHS Progressive Scan”)
