JVC DR-MV5S manual DVD Deck Only, DVD REC Link, REC Mode

36 EN TIMER RECORDING

	Automatic Satellite Program Recording		● Make sure the DBS receiver is connected to the unit’s [S VIDEO/
			VIDEO/AUDIO INPUT L-1] connectors.
	(DVD Deck Only)		● Program the timer on the DBS receiver.
			● Slide the TV/DVD switch to DVD.
			1 Load a recordable disc.
This function allows you to automatically record a satellite program
which is timer-programed on your external DBS receiver. Connect			2 Press DVD so that the DVD lamp lights up on the unit.
a DBS receiver to the unit’s [S VIDEO/VIDEO/AUDIO INPUT L-1]			3 Press REC MODE repeatedly to set the recording mode.
connectors and program the timer on the DBS receiver. The unit
			4 Set “REAR AUX L-1” to “VIDEO” for the VIDEO input connector,
starts or stops recording by the signals input from the DBS
receiver. After recording, the unit’s power shuts off automatically.			or “S-VIDEO” for the S-VIDEO input connector, depending on the
● You can also connect the cable box if it has a timer.			connector being used. ( pg. 73)
			5 Press and hold REC LINK for about 2 seconds to engage the
ATTENTION:			Automatic Satellite Program Recording mode. “ ” and “R-LK”
● Be sure not to turn on the DBS receiver before the program is			appear on the front display panel.
		executed; otherwise, the unit will start recording when the DBS	NOTES:
		receiver’s power is turned on.
			● To disengage the Automatic Satellite Program Recording mode,
● If you have connected another appliance other than a DBS
			press REC LINK.
		receiver to the [S VIDEO/VIDEO/AUDIO INPUT L-1] connectors,
			● If the unit’s power is off, it is not possible to engage the Automatic
		be sure not to engage the Automatic Satellite Program Recording
			Satellite Program Recording mode.
		mode; otherwise, the unit will start recording when the connected
			● In step 5, if “ ” blinks quickly on the front display panel even though
		appliance’s power is turned on.
			your DBS receiver’s power is off, Automatic Satellite Program
● Automatic Satellite Program Recording and timer-recording cannot
			Recording will not work properly with that DBS receiver*. If this is the
		be done at the same time.
			case, perform “Manual Timer Programing” ( pg. 32) to timer-record
			a satellite program.

DVD

REC LINK

*Some DBS receivers output signals even if the power is off. Automatic Satellite Program Recording is not possible with those DBS receivers.

●“ ” blinks on the front display panel while Automatic Satellite Program Recording is in progress.

●For timer programing of the DBS receiver, refer to the instruction manual of the DBS receiver.

●Automatic Satellite Program Recording is not possible if your DBS receiver does not have a timer.

●Pressing the unit’s 1 button while Automatic Satellite Program Recording is in progress turns off the unit’s power and disengages the Automatic Satellite Program Recording mode.

●If there are more than one satellite programs you wish to record with Automatic Satellite Program Recording, it is not possible to set different recording modes for each program.

●Depending on the type of DBS receiver, the unit may not record a slight portion of the beginning of the program or may record slightly longer than the actual length of the program.

●If you engage the Automatic Satellite Program Recording mode when

the DBS receiver’s power is on, the unit will not start Automatic Satellite Program Recording even though “ ” blinks on the front display panel. When the DBS receiver shuts off once and is turned back on again, the unit starts recording.

●You can also record a program from your cable system in the same way if the system has a timer.

REC MODE