JVC DR-MV5S Or An Amplifier With Built-in DTS, Connecting To A Dolby Digital Decoder, Cautions

	SYSTEM CONNECTIONS EN 71
Connecting To A Dolby Digital Decoder	1 Connect the unit and a Dolby Digital Decoder or an amplifier
	with built-in DTS using an optional coaxial cable.
Or An Amplifier With Built-in DTS	NOTES:
	● For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY
These instructions enable you to connect your unit to a Dolby	DIGITAL/PCM”. ( pg. 72)
	● For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”.
Digital Decoder or an amplifier with built-in DTS.
	( pg. 72)
	CAUTIONS:
	● This unit has a dynamic range of more than 110 dB with regards to its
	Hi-Fi audio capability. It is recommended that you check the
	maximum level if you are going to listen to the Hi-Fi audio signals
	through a stereo amplifier. A sudden surge in the input level to the
	speakers may damage them.
	● Some speakers and televisions are specially shielded to prevent
	television interference. If both are of the non-shielded type, do not
	place the speakers adjacent to the TV set as this can adversely affect
	the playback picture.

Dolby Digital Decoder or amplifier with built-in DTS

To DIGITAL AUDIO input

Coaxial cable (not supplied)

To [DIGITAL AUDIO

OUT (COAXIAL)]

Rear of unit