<LAN Setting>
Setting the
Troubleshooting
Solutions to common problems related to the monitor are described here. If none of the solutions presented here solves the problem, unplug the monitor and consult an authorized dealer or service center.
|
|
| Click to finish the operation. |
Menu 1 | Menu 2 | Menu 3 | Menu 4 |
Main Control | Motion Sensor Setting | LAN Setting | |
|
|
| Log Out |
LAN Setting |
|
| 3 |
Power is not supplied.
]Is the power cord connected (see page 6)?
]Is the main power switch (POWER) turned on (see page 10)?
No picture.
] Is the correct input selected (see page 10)? |
] Connect the signal cable firmly. |
1
2
|
|
|
MAC Address: | 00:04:A3:00:00:05 |
|
IP Address: | 10.52.41.39 |
|
Subnet Mask: | 255.255.255.0 |
|
Default Gateway: | 10.52.41.254 |
|
DNS Server: | 192.168.0.1 |
|
|
|
|
Enter Log In Name:
ReEnter to Confirm:
OK
Set EMail Address
EMail Address to Send
SMTP Server
Mail Account
Mail Password
OK 
Get Status 
All Clear
Error Notification Mail | Send |
45
] Check if the input signal format is acceptable |
on the monitor. |
] Are the devices connected correctly (see page |
6)? |
] Are signals being input from the connected |
devices? |
] Is brightness adjusted correctly (see page 13)? |
No sound.
]Is the volume set at minimum (see page 10)?
]Is the muting function activated (see page 10)?
]Is “AUDIO ASSIGN” set correctly (see page 13)?
1Displays the current network setting.
2Sets the
• Up to 8 characters can be used.
Click “OK” to confirm the
3
• For details about the setting, consult the person
in charge of the mail server.
1Enter the mail address for the monitor.
2Enter the
• Up to 48 characters can be used for each
mail address.
3Enter the SMTP server address (up to 32 characters).
4Enter the
5Enter the Email password of the monitor (up to 16 characters)
Click “OK” to confirm the mail setting.
Click “Get Status” to load the current settings. Click “All Clear” and then “OK” to delete the mail setting.
4Check here to receive the error notification from the monitor.
The error message is sent to the mail address specified in
5Click to send the test mail.
•You may not be able to send
•
•“POP before SMTP” is not supported.
]See page 27 for details.
The remote control does not work.
] Are the batteries installed correctly (see page 5)? ] Are the batteries exhausted?
] Is the front end of the remote control pointing toward the remote sensor?
] Is there any object blocking the path between the remote control and the remote sensor?
] Is the monitor too far away from you?
]Are the functions of motion sensor set to “ON”?
25
