JVC GM X50U manual Monitor Rear Views, Video a terminals COMPONENT/RGB B input terminals

Monitor: Rear Views 1

	1			2				3
AUDIO		VIDEO	AUDIO	VIDEO		AUDIO			VIDEO
L/MONO			L/MONO			L/MONO
R	IN	OUT	R	IN	Y/C IN	R	Y/G	Pb/B	Pr/R	HD/Cs	VD
VIDEO A				VIDEO B			COMPONENT/RGB B

1 VIDEO A terminals (page 11)	3 COMPONENT/RGB B input terminals (page 11)
AUDIO (L/MONO, R) input terminals (pin jack)	AUDIO (L/MONO, R) input terminals (pin jack)
Connect these terminals to the audio input terminals of a	Connect these terminals to the audio output terminals of
VCR, etc.	the other equipment.
VIDEO IN terminal (BNC)	G, B, R, HD/Cs, VD (VIDEO) input terminals (BNC)
Connect this terminal to the video output terminal of a	Connect these terminals to the following output terminals
VCR, etc.	of a personal computer or other equipment:
VIDEO OUT terminal (BNC)	– Analog RGB signal output terminals
	– Horizontal sync (HD) signal or composite (Cs) signal
Connect this terminal to the video input terminal of
	output terminal
another monitor, etc.
	– Vertical sync (VD) signal output terminal
Note:
	Notes:
• Since the video output terminals on this Monitor are
	• External sync signals are automatically detected when
loop-through terminals, the devices connected to this
	they come in.
video output terminal should be correctly terminated.
	• When both horizontal (HD)/vertical (VD) sync and
Otherwise, pictures become abnormally bright or the
	composite (Cs) sync are connected, HD/VD sync signals
Monitor screen gets affected abnormally.
	will be used.

2VIDEO B terminals (page 11)

AUDIO (L/MONO, R) input terminals (pin jack) Connect these terminals to the audio output terminals of a VCR, etc.

Y/C (S video) IN terminal (mini DIN 4pin)

Connect this terminal to the S-video output terminal of a VCR, etc.

VIDEO IN terminal (pin jack)

Connect this terminal to the video output terminal of a VCR, etc.

Note:

•When both the video and S-video terminals are connected, the S-video terminal will have priority.

Y, Pb, Pr (VIDEO) input terminals (BNC)

Connect these terminals to the component signal output terminals of NTSC or high-vision equipment.

Note:

•When these terminals are used as the component terminals (Y, Pb, Pr)—see “Setting the COMPONENT/ RGB B Input” on page 20, external sync signals (HD/Cs, VD) cannot be used.

5