JVC GM X50U manual Cable with stereo, Mini jacks

Connections (Continued)
Typical connections								❊ For connection, see “Connecting an
		Personal computer
Personal computer							Remote control	External Control Unit” below.
(used as the playback source)		(used to control the Monitor)
							(supplied)	Amplifier, etc.
						MENU/EXIT
					VOLUME MUTING
					A RGB		B
							VIDEO
					.COMPO		A
					SELECT INPUT
					ASPECT	DISPLAY
					ON	POWER	OFF
To	To		To				Cable with stereo	To
audiooutput	monitoroutput		RS-232C					audioinput
							mini jacks
							(not supplied)
				❊				Power cord (supplied)
								To a wall outlet
	AUDIO				OUT
				MAKE	L
	IN		RS-232C	WIRED	R
		RGB A	REMOTE		AUDIO		AC IN	POWER

Connecting an External Control Unit

When connecting the external control unit to the MAKE terminal, you can operate the following functions through the MAKE terminal;

•Turn on or off the Monitor.

Preparation: The POWER switch on the rear must be set to “(on)” (so that the Monitor is in standby mode).

•Select the input.

Preparation: “REMOTE SWITCH” should be set correctly to select your desired input (see page 24).

Notes:

•There is no remote control on/off switch. When a plug is inserted to the MAKE terminal, remote control through the external control unit is automatically activated.

•When the other REMOTE terminals are used at the same time, transmitted commands through the MAKE terminal have priority over those through the other terminals.

• MAKE terminal

6	5	Pin number	Signal name
4	3	1	GND
		2	GND
2	1
		3	SW2
		4	SW1
		5	SW DET
		6	GND

• External control unit

Signals

transmitted

=	TTL level
	H: Power Off	L: Power On
=
	H: Input A*	L: Input B*
=
	H: Not connected	L: Connected

*Input A and Input B will be determined by the “REMOTE SWITCH” setting.

IMPORTANT:

External control unit is not commercially available in the market. When you need it, consult your dealer.

12