EN#!
Dubbing To A Video Unit Equipped
With A DV IN Connector
(Digital Dubbing)
It is also possible to copy recorded scenes from the camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.
| To DV | |
Core filter | DV cable | |
(optional) | ||
| ||
To DV IN |
|
Video unit equipped with DV connector
1Make sure all units are turned off.
2Connect this camcorder to a video unit equipped with a DV input connector using a DV cable as shown in the illustration.
3Set this camcorder’s VIDEO/MEMORY Switch to “VIDEO”.
4Set this camcorder’s Power Switch to “PLAY” while pressing down the Lock Button located on the switch.
5Turn on the video unit’s power.
6Insert the source cassette in this camcorder.
7Insert the recording cassette in the video unit.
8Press PLAY (4/9) on this camcorder to start playback of the source cassette.
9At the point you want to start dubbing, engage the video unit’s Record mode.
10To pause dubbing, engage the video unit’s
11Repeat steps 8 – 10 for additional editing. Stop the video unit and camcorder.
NOTES:
●It is recommended to use the AC Adapter as the power supply instead of the battery pack.
( pg. 11)
●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.
●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.
●Even though the DV cable is connected correctly, sometimes the image may not appear in step 9. If this occurs, turn off the power and make connections again.
●If “Playback Zoom” ( pg. 58) or “Playback Special Effects” ( pg. 58) is attempted or SNAPSHOT is pressed during playback, only the original playback image recorded on the tape is output from the DV connector.
●When using a DV cable, be sure to use the optional JVC
ADVANCED FEATURES
