![](/images/new-backgrounds/1292302/292302107x1.webp)
#"EN | DUBBING (cont.) |
Dubbing From A Video Unit
Equipped With A DV OUT
Connector (Digital Dubbing)
It is also possible to copy recorded scenes from another video unit equipped with a DV connector onto the camcorder. Since a digital signal is sent, there is little if any image or sound deterioration.
| To DV | |
Core filter | DV cable | |
(optional) | ||
| ||
To DV OUT |
|
Video unit equipped with DV connector
1Make sure all units are turned off.
2Connect this camcorder to a video unit equipped with a DV output connector using a DV cable as shown in the illustration.
3Set this camcorder’s VIDEO/MEMORY Switch to “VIDEO”.
4Set this camcorder’s Power Switch to “PLAY” while pressing down the Lock Button located on the switch.
5Set “REC MODE” to “SP” or “LP”. ( pg. 31, 34)
6Turn on the video unit’s power.
7Insert the source cassette in the video unit.
8Insert the recording cassette in this camcorder.
9Press the Recording Start/Stop Button to engage the
●The “ DV. IN ” indication appears on the screen.
10Press the Recording Start/Stop Button to start recording.
●The indication rotates.
11Press the Recording Start/Stop Button again to engage the
●The indication stops rotating.
12Repeat steps 10 – 11 for additional editing. Stop the video unit and camcorder.
NOTES:
●It is recommended to use the AC Adapter as the power supply instead of the battery pack.
( pg. 11)
●If no image is displayed on the LCD monitor, set “S/AV INPUT” to “OFF”. ( pg. 31, 40)
●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.
●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.
●Even though the DV cable is connected correctly, sometimes the image may not appear in step 9. If this occurs, turn off the power and make connections again.
●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting. ( pg. 34)
●When using a DV cable, be sure to use the optional JVC