JVC GR-D200 manual Select Scenes, Repeat steps 8 through 11 to register, Additional scenes

T I ME CODE – – : – –

TOTAL 0 0 : 00

I N

1 – – – – : – – ~

2~

3~

4~

5~

6~

7~

8~

OUT MODE

Selected parameter

	EN￿$!
Select Scenes	11 If using Playback Special Effects, press EFFECT.
	( pg. 58)
FADE/WIPE	12 Repeat steps 8 through 11 to register
REW	additional scenes.
FF	● To change previously registered points, press
	CANCEL on the remote control. The registered
PLAY	points disappear, one at a time, from the most
R.A.EDIT	recently registered point.
	● If you are not using Wipe/Fader or Program AE
ON/OFF	with special effects, repeat steps 8 and 9 only.

CANCEL

EFFECT EDIT IN/OUT

RM-V717U (optional)

6Press PLAY (U) and then press R.A.EDIT ON/OFF on the remote control.

The Random Assemble Editing Menu appears.

7 If using a Wipe/Fader at the beginning of the scene, press FADE/WIPE on the remote control. ● Cycle through the

effects by pressing repeatedly, and stop

when the one you want is displayed.

●You cannot use a Picture Wipe/Dissolve at the beginning of Program 1.

8At the beginning of the scene, press EDIT IN/ OUT on the remote control. The Edit-In position appears in the Random Assemble Editing Menu.

9At the end of the scene, press EDIT IN/OUT. The Edit-Out position appears in the Random Assemble Editing Menu.

10If using a Wipe/Fader at the end of the scene, press FADE/WIPE.

●Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

●If you select a Wipe/Fader effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point.

●You cannot use a Picture Wipe/Dissolve at the end of the last scene.

●When you use Fader/Wipe effects, that time is included in the total time (this does not apply to Picture Wipe/Dissolve.)

NOTES:

●When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between them.

●If the search time for an in-point exceeds

5 minutes, the recording deck’s Record-Standby mode will be cancelled and editing will not take place.

●If there are blank portions before or after the Edit- In and Edit-Out points, a blue screen may be included in the edited version.

●Since time codes register time only as accurately as seconds, the time code total time may not match the total program time exactly.

●Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.

●If you select Sepia or Monotone mode from Program AE with special effects, you cannot use the Dissolve or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during recording, then use the Dissolve or Black & White Fader during Random Assemble Editing.

●It is not possible to use Wipe/Fader effects and Program AE with special effects during Random Assemble Editing using a DV cable.

ADVANCED FEATURES

CONTINUED ON NEXT PAGE