EN'
Automatic Demonstration
Automatic Demonstration takes place when “DEMO MODE” is set to “ON”
Lock Button
Power Switch
SELECT/SET |
Button |
+/- Button |
MENU Button
Sub Menu
Automatic Demonstration starts when there is no operation for about 3 minutes after the Power Switch is set to “A” or “M” and no cassette is in the camcorder.
Performing any operation during the demonstration stops the demonstration temporarily. If no operation is performed for more than 3 minute after that, the demonstration will resume.
“DEMO MODE” remains “ON” even if the camcorder power is turned off.
To cancel Automatic Demonstration
1Set the Power Switch to “M” while pressing down the Lock Button located on the switch.
2Open the LCD monitor fully, or pull out the viewfinder fully.
3Press MENU. The Menu Screen appears.
4Press + or – to select “s”, and press SELECT/ SET. The SYSTEM Menu appears.
5Press + or – to select “DEMO MODE”, and press SELECT/SET. The Sub Menu appears.
6Press + or – to select “OFF”, and press SELECT/ SET.
7Press + or – to select “BRETURN”, and press SELECT/SET twice. The normal screen appears.
NOTE:
Detach the lens cap to see the actual changes of the Automatic Demonstration activated on the LCD monitor or viewfinder.
AUTOMATIC DEMONSTRATION
SYSTEM
DEMO MODE – OFF ON
