$&EN | DETAILS |
|
|
ITEMS | NOTES |
V Power ( pg. 10) | ● Perform charging where the temperature is between 10°C and 35°C (50°F and |
| 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature range for charging. If |
| the environment is too cold, charging may be incomplete. |
| ● Charging times are for a fully discharged battery pack. |
| ● Charging time varies according to the ambient temperature and the status of the |
| battery pack. |
| ● To avoid interference with reception, do not use the AC Adapter near a radio. |
| ● Since the AC Adapter processes electricity internally, it becomes warm during use. |
| Be sure to use it only in |
| ● The following operation stops charging: |
| • Set the Power Switch to “PLAY”, “A” or “M”. |
| • Disconnect the AC Adapter from the camcorder. |
| • Unplug the AC Adapter from the AC outlet. |
| • Detach the battery from the camcorder. |
|
|
V VIDEO | ● When you use the LCD monitor outdoors in direct sunlight, the LCD monitor may |
RECORDING | be difficult to see. If this happens, use the viewfinder instead. |
( pg. 17) | ● The cassette holder cannot be opened unless a power supply is attached. |
| ● There may be a delay after you open the cassette holder cover until the cassette |
| holder opens. Do not use force. |
| ● Once the cassette holder is closed, it recedes automatically. Wait until it recedes |
| completely before closing the cassette holder cover. |
| ● When the Recording Start/Stop button is pressed, it may take a few seconds before |
| actual recording starts. The “T” indicator starts rotating when the camcorder |
| actually starts recording. |
| ● The time required to calculate and display the remaining tape length, and the |
| accuracy of the calculation, may vary according to the type of tape used. |
| ● “TAPE END” appears when the tape reaches its end, and the power goes off |
| automatically if left in this condition for 5 minutes. “TAPE END” also appears |
| when a cassette at its end is loaded. |
|
|
Page 68
Image 68
