JVC GY-DV5000 manual Attaching the Zoom Lens, Attaching the Viewfinder, Pin Hole, Ring

3. BASIC SYSTEM CONNECTIONS AND ADJUSTMENTS

3-2 Attaching the Zoom Lens

Pin

1. 4.

3.

Hole

2.

When unplugging the cable connector, first remove the lens itself. Then grasp this portion and pull out.

1. Loosen the mount ring.

2. Connect the cable connector.

3. Attach the lens with its pin aligned with the hole in the mount.

4. Tighten the mount ring.

CAUTION:

●Be sure to tighten the mount ring completely. Incomplete tightening may result in the lens dropping off or disturbed back focus.

●Set the GY-DV5000’s power switch to “OFF” before the zoom lens is attached or detached.

3-3 Attaching the Viewfinder

By changing the position of the viewfinder mount base on the camera the viewfinder can be observed with either the left or the right eye.

When shipped from the factory, the viewfinder mount base is attached so that the viewfinder is mounted for right eye use. After the viewfinder has been attached, the viewfinder can be slid forward.

1.

Sliding securing ring

Screw holes for left eye use 3.

2. Cap Fastening screws 4. Cap

HEXAGON WRENCH

5.1. Mounting guide

4.

Stopper screw

Viewfinder mount base

2.

Connector

■Observing the viewfinder with the left eye

Change the mounting position of the viewfinder mount base.

1. Loosen the two fastening screws of the viewfinder mount base with an hexagon wrench (Provided) and then remove the viewfinder mount base (including the sliding securing ring).

2. Remove the cap.

3. Mount the viewfinder mount base (including the sliding securing ring) at the screw holes for left eye use and tighten the screw with the hexagon wrench (Provided).

4. Attach the removed cap on the right-eye side.

■Attaching the Viewfinder

1. Loosen the stopper screw.

2. Connect the cable connector.

3. Attach the viewfinder with its guide aligned with the shoe.

4. Tighten the stopper screw.

5. Tighten the sliding securing ring.

Viewfinder 1.	Sliding securing
3.	ring

2.

*Reverse the procedure to remove the viewfinder.

■Sliding the viewfinder forward

1. Loosen the sliding securing ring.

2. Slide the viewfinder forward.

3. Tighten the sliding securing ring.

CAUTION:

●Set the GY-DV5000’s power switch to “OFF” before the viewfinder is attached or detached.

E-30