JVC GY-DV5000 manual Attaching the Microphone Provided, Attaching the Microphone Optional

3. BASIC SYSTEM CONNECTIONS AND ADJUSTMENTS

3-4 Attaching the Microphone (Provided)

	1.3.		Connect the provided microphone to the viewfinder. The
			provided microphone is a phantom microphone.
		4.	1. Loosen the stopper screw on the viewfinder.
		2.	2. Attach the microphone to the attachment guide on the
			viewfinder as illustrated.
			3. Confirm that there is no gap between the microphone and
			the viewfinder, and then tighten the stopper screw.
			4. Tighten the screw on the microphone. The microphone
			should be firmly attached.
			5. Connect the cable from the microphone to the FRONT
			AUDIO IN connector on the camera.
		5.	6. Secure the microphone cable using the cable clamp
			provided on the front side of the microphone holder.
Microphone cable	Cable clamp	6.	MEMO:
			When attaching the viewfinder for use with the left eye,

VF	the provided microphone cannot be attached. In this case,
	use the optional microphone holder KA-A50U and
	microphones MV-P615U/618U (phantom microphone).

3-5 Attaching the Microphone (Optional)

2,4.

KA-A50U

Microphone holder

1.

3.

MV-P615U/MV-P618U

FRONT AUDIO INPUT Microphone cable 5.

With the optional KA-A50U microphone holder, the optional microphones MV-P615U (phantom microphone) and MV- P618U (phantom microphone) can be used.

<Attaching the Microphone Using KA-A50U>

1. Secure the microphone holder with 2 screws.

2. Turn the small knob located on the outer side of the microphone holder counterclockwise to loosen it, and loosen the large knob located on the inner side in the same way. Rotate the large knob fully counterclockwise to open the holder.

3. Attach the microphone to the microphone holder at the designated place so that the microphone does not interfere with the cassette cover.

4. Set the microphone holder so that the height is level, and tighten the inside and outside knobs to secure the microphone.

5. Connect the microphone cable to the FRONT AUDIO IN connector.

●When the microphone is connected to REAR AUDIO IN connector on the rear panel, set the CH-1 or CH-2 AUDIO input selector switch to REAR.

6.Secure the microphone cable using the cable clamp located on the front side of the microphone holder.

6.7. Make sure to perform the correct settings for use of a phantom microphone.

☞ See “FRONT/REAR AUDIO INPUT switch !” on page 15.

CAUTION:

●When the light mounted on the camera is used at the same time, if the microphone in use has a long sound collecting section, the microphone’s shadow may appear in the image.

E-31