JVC HM-DH5U 30 EN, Adjusting tracking condition Selecting monitor sound, Activate manual tracking

Filename [HM-DH5U_Eng.fm]

HM-DH5U_Eng.fm Page 30 Tuesday, June 1, 2004 4:09 PM Masterpage:Left-FullCol

30 EN	PLAYBACK (cont.)
C Adjusting tracking condition	D Selecting monitor sound
— Tracking Adjustments	— Audio Monitor
Automatic tracking adjustment	You can select the desired monitor sound.

This VCR automatically adjusts the tracking condition. Whenever you insert a tape and start playback, automatic tracking starts working and continuously analyzes the signal to enable optimum picture quality during playback.

While playing back a tape on which stereo sound or SAP sound is recorded, press [A. MONITOR] on the Remote or [AUDIO MONITOR] on the front panel.

Each time you press the button, sound changes as follows:

Manual tracking adjustment

If automatic tracking cannot eliminate noises well during playback, use the manual tracking following the procedures below.

• You can also use the manual tracking during slow

motion playback (A page 34). During slow motion

playback, simply press [CHANNEL +] or [–] on the VCR

(or [TV/VCR CH +] or [–] on the Remote) to adjust

S-VHS/VHS
L R	L

MIX

R

NORMAL

tracking.

1 Activate manual tracking

Press [CHANNEL +] and [–] on the front panel at the same time during playback.

2 Eliminate the noises on the TV screen

Press [CHANNEL +] or [–].

•Press it briefly for a fine adjustment, or press and hold for a coarse adjustment. Watch the screen and continue adjustment until optimum picture and sound quality are achieved.

•To reactivate automatic tracking, press [CHANNEL +] and [–] on the front panel at the same time. The automatic tracking becomes active again.

“UL RV”	: Normally select this.
	Hi-Fi sound is played back.
“UL”	: Sound on the left Hi-Fi channel is
	played back.
“RV”	: Sound on the right Hi-Fi channel is
	played back.

“NORMAL” : Sound on the normal track is played

	back.
“MIX”	: Both sounds on the Hi-Fi track and
	normal track are mixed and played
	back.

D-VHS

L R L R

“UL RV” : Normally select this.

“UL” : Sound on the left channel is played back.

“RV” : Sound on the right channel is played back.

NOTES:

•The above indication appears when “SUPERIMPOSE” is set to “ON” (A page 66), though the monitor sound changes in sequence.

•If the tape being played back has no Hi-Fi sound track, the normal sound track will be heard regardless of this setting.