JVC HM-DH5U Select video input terminal, Set Picture Control to Edit, Connection with the VCR

Filename [HM-DH5U_Eng.fm]

HM-DH5U_Eng.fm Page 75 Tuesday, June 1, 2004 4:17 PM Masterpage:Right-FullCol

EN 75

BConnection with the VCR

Connect an audio/S-video cable between the playback VCR’s audio/S-video output connectors and the recording VCR’s [AUDIO/ S VIDEO INPUT] connectors.

•When using this VCR as the recording VCR, connect this VCR’s [AUDIO/S VIDEO INPUT] connectors to the audio/S-video output connectors on the other VCR.

If the playback VCR is monaural, connect the audio output connector on the playback VCR to the [AUDIO L INPUT] connector on this VCR.

NOTE:

If another VCR does not have S-video input/output connectors, use a video cable.

E Select video input terminal

Access the “IN/OUT FUNCTION” screen (A page 65).

When using [S VIDEO] terminal, set “FRONT AUX F-1” (or “REAR AUX L-1” (or “L-2”) if you use the connectors on the rear) to “S-VIDEO”.When using [VIDEO] terminal, set “FRONT AUX F-1” (or “REAR AUX L-1” (or “L-2”) if you use the connectors on the rear) to “VIDEO”.

F Set “PICTURE CONTROL” to “EDIT”

Access the “VIDEO FUNCTION” screen (A page 63).

B Load a cassette

Insert the cassette to be recorded on into this VCR (for recording).

C Select input location on this VCR

[L-1] or [L-2] — when connecting the device to the [AUDIO/VIDEO INPUT] or

[AUDIO/S VIDEO INPUT] connectors on the rear panel.

[F-1] — when connecting the device to the [AUDIO/VIDEO] or [AUDIO/S VIDEO] input connectors on the front panel.

On the front panel:

Press [CHANNEL +/–].

On the Remote:

Press the ‘Number’ key [0 (AUX)] or [TV/VCR CH +/–].

NOTE:

When using this VCR as the recording VCR, set the video input terminal setting correctly. This setting selects either the S-Video or composite video (A page 65).

G Start playback

Press [PLAY (I)] on the connected device.

NOTE:

If the connected device is equipped with a superimpose/ OSD disable feature then set it to “OFF” before starting playback.

H Start recording

On the front panel:

Press [REC (R)].

On the Remote:

Press [REC (R)] and [PLAY (I)] at the same time.

To use a Master Edit Control-equipped JVC camcorder

AAccess the “ADDITIONAL” screen (A page 66), then set “AV COMPU-LINK” to “OFF” after per- forming step F.

•The REMOTE PAUSE/AV COMPULINK connector works as a Remote Pause connector when “AV COMPU-LINK” is set to “OFF”.

•For details, refer to the camcorder’s instruction manual.

BEngage the VCR’s recording pause mode.

D Set recording speed

Press [REC SPEED] to set the tape speed.

Input Source		Selectable Recording Speed
(Playback device)		(Recording device: This VCR)
Analog	D-VHS	HS, STD, LS3
input	S-VHS/VHS	SP, EP

NOTES:

•Be sure to select “AUTO” for “PICTURE CONTROL” (or

“NORM” when “V. CALIBRATION” is set to “OFF”) after you finish dubbing the tapes (A page 63).

•It is impossible to perform dubbing properly only with an audio cable. Connect also the video or S-video cable.