JVC HM-DH5U manual 82 EN

Filename [HM-DH5U_Eng.fm]

HM-DH5U_Eng.fm Page 82 Wednesday, June 2, 2004 2:07 PM Masterpage:Left-FullCol

82 EN			TROUBLESHOOTING (cont.)
VIDEO NAVIGATION
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
2.	The VCR cannot search for the	• Two (or more) tape numbers are	Video Navigation cannot work
	desired program.	recorded on one tape.	correctly on a tape if it has more than
			one tape number. If this happens,
			fast-forward the tape up to its end,
		• The inserted program is not	eject it, and try it again.
		recorded on this VCR.	It is impossible to search the desired
			program which is not recorded on
			this VCR using Video Navigation.
3.	“MEMORY FULL” appears on the	• The VCR’s memory for Video	Check the remaining memory
	screen when you try to start	Navigation is fully recorded.	(A page 61). If it is full, delete
	recording.		unnecessary Video Navigation
			information (A pages 60, 61).
4.	The information data for Video	• The VCR’s memory for Video	Check the remaining memory
	Navigation is not registered.	Navigation is fully recorded.	(A page 61). If it is full, delete
			unnecessary Video Navigation
			information (A pages 60, 61).
		• “NAVIGATION” is set to “OFF”.	Set “NAVIGATION” to “ON”
			(A page 52).
		• The recording time is not enough.	For details on the recording time for
			Video Navigation, refer to ‘NOTES’
			on page 51.
OTHER PROBLEMS
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	When scanning channels, some	• Those channels have been preset to	If you need the skipped channels,
	of them are skipped over.	be skipped.	restore them (A page 21).
2.	The channel cannot be changed.	• Recording is in progress.	Press [PAUSE (W)] to pause the
			recording, change channels, then
			press [PLAY (I)] to resume recording.
3.	The Remote will not operate your	• The brand codes are set incorrectly.	Reset the correct brand codes
	TV or cable box or DBS receiver.		(A pages 76, 77).
4.	Even though Auto or Semiauto	• The clock setting data received	Select a different host channel during
	Clock Set has been performed,	from the host channel is incorrect.	Semiauto Clock Set (A page 18), or
	the clock is incorrect.		perform Manual Clock Set
			(A page 19).
5.	“PM” blinks on the front display	• The VCR do not work properly.	Unplug the AC power plug once,
	panel.		then plug it again.
6.	The subtitles and the menu screen	• The subtitle display on the TV is set	Set it to off.
	are overlapped.	to on.
7.	The subtitles cannot be displayed.	• You are viewing the program in EE	Make use of the analog connection
		mode through the HDMI	(Component Video, S-Video or
		connection.	Video), and set “TV OUTPUT 2” to
			“ALLto480i” (A page 65). However,
			if the picture is of 480p image format,
			the subtitles cannot be displayed.