Filename [HM-DH5U_Eng.fm]

HM-DH5U_Eng.fm Page 78 Wednesday, June 2, 2004 1:30 PM

Masterpage:Left-FullCol

 

78 EN

MULTI-BRAND REMOTE CONTROL (cont.)

Changing

Remote Control

Code

The Remote is capable of controlling four JVC video recorders independently. Each of VCRs can respond to one of four codes (A, B, C or D).

This Remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily change your Remote and the VCR to send and respond to B, C or D code signals.

When using four JVC VCRs, set the four VCRs and their Remotes to different codes, so that the Remotes can operate these VCRs separately.

[POWER]

[PLAY(I)]

A

CE

 

VCR CABLE

 

TV /DBS

B- A,C

 

B- B

B- C

NOTE:

When “POWER SAVE” is set to “ON”, you can not change the remote control code. Before changing the code, set “POWER SAVE” to “OFF” (A page 67).

A Set remote operation mode

Set the [VCR/TV/CABLE/DBS] selector to [VCR].

B Set remote control code for

Remote

APress and hold [A/B/C/D].

BPress the ‘Number’ key [1] for A code control signals, [2] for B code control signals, [3] for C code control signals and [4] for D code con- trol signals.

CPress [STOP (L)], and release [A/B/C/D].

C Turn off VCR

Press [POWER] on the VCR.

D Check remote control code for VCR

Press [PLAY (I)] on the VCR for more than 5 seconds.

The code currently set appears on the front display panel.

E Turn on VCR

Press [POWER] on the Remote.

The code transmitted from the Remote blinks for a few seconds on the front display panel.

After the code disappears on the front display panel, make sure that the VCR is turned on by pressing [POWER] on the Remote.

To control four VCRs with the same Remote

You can control four JVC VCRs by switching the remote control code for the Remote between A,B, C and D as in step B , keeping four VCRs to different control codes.

Press the ‘Number’ key [1] for A code control signals, [2] for B code control signals, [3] for C code control signals and [4] for D code control signals. (To change only the remote control code for the Remote, DO NOT perform steps C to E.)

(E.g.) To set Remote to B code:

STOP

A/B/C/D

Release

ABC

Hold

Press in succession

down

 

Page 78
Image 78
JVC HM-DH5U manual Changing Remote Control Code, 78 EN