
EN 21
Turn on the VCR and the TV, and select the VCR channel 3 or 4 (or AV mode) on the TV.
3
2 34
VCR TV CABLE/DBS
1 2 3
4 5 6
7 8 9
0
3
234
Setting DBS receiver output channel & brand
After installation, set the DBS receiver’s output channel and its brand correctly; otherwise, the Controller cannot work correctly.
1 Turn on DBS receiver
Select a channel other than channel 55, 100 or 205 on your DBS receiver.
2Access Main Menu screen on VCR
Press MENU.
3 Access Initial Set screen
On the front panel:
Press CH5° to move the highlight bar (arrow) to “INITIAL SET”, then press OK.
On the Remote:
Press %Þ to move the highlight bar (arrow) to “INITIAL SET”, then press OK or #.
4 Access DBS Receiver Set screen
On the front panel: Press CH5° to move the highlight bar (arrow) to “DBS RECEIVER SET”, then press OK.
On the Remote: Press %Þ to move the highlight bar (arrow) to
“DBS RECEIVER SET”, then press OK or #.
5 Select DBS receiver output channel Your selection depends on how your DBS receiver is connected to your VCR.
If your DBS receiver is connected to your VCR’s ANTENNA IN terminal on the rear
Press CH 5° on the front panel or %Þ on the Remote until the channel number
representing the DBS receiver’s output (CH3 or CH4) appears on the screen.
If your DBS receiver is connected to your VCR’s AUDIO/VIDEO IN connectors on the front panel
Press CH 5° on the front panel or %Þ on the Remote until “ON
If your DBS receiver is connected to your VCR’s AUDIO/VIDEO IN connectors on the rear panel Press CH 5° on the front panel or %Þ on the Remote until “ON
If you do not use a DBS receiver
Press CH 5° on the front panel or %Þ on the Remote until “OFF” appears on the screen.