JVC LVT1627-001A manual Calibration, GPS Antenna, Speed Signal, Parking Brake, Connection

Calibration

Before using the Navigation System first time, it is required to calibrate the Navigation System.

•After deleting the calibration data (☞ [46] Reset Calibration) or changing the installation angle (☞ [46] Installation Angle), calibration is also required.

1Display the map screen.

2Display the detail screen and check the connections.

[Hold]

GPS Antenna

•OK ] Connection is OK. ([5]: number of the GPS satellites whose signal is detected.)

•NG ] Antenna is disconnected or short-circuited.

Speed Signal

Drive the car for a while.

•If the number increases as you speed up the car, connection is OK.

Parking Brake

Calibrating... Detail

Sensor Status

Learning Lv.	:0
GPS Antenna	:OK [5]
Speed Signal	:12.0
Parking Brake	:On
Direction	:Forward
Calibrating...

:Calibration not in progress.

: Calibration in progress.

Step on the brake pedal, then disengage and engage the parking brake repeatedly.

• If Off appears when disengaged and On appears when engaged, connection is OK.

If the result is not good, check the connection.

•You can see detailed information on the items of Sensor Status in Information ]

Connection. (☞ [43])

3After confirming all the above connections, drive the car to start calibration.

•This process can take five minutes or more depending on the average speed driven.

•A certain speed (greater than 25 mi/h (40 km/h)) is required for calibration.

•Calibration time differs among the cars.

•During calibrating, you can use the AV functions of the unit (you can listen to the music, etc.)

•If you turn off the ignition switch, calibration is temporarily stopped. When it is turned on, calibration will restart.

Once calibration is finished, the arrowhead icon turns red and the current position information appears instead of Calibrating.... Learning Lv. (maximum level is 4) reaches 1 after calibration finished.

Navigation (functions such as guidance or route simulation) cannot be used until calibration is complete.

Initial settings 9