Digital connection | 7 Digital output terminal | ||
This receiver is equipped with three DIGITAL IN | You can connect any digital components which have an optical | ||
digital input terminal. | |||
digital coaxial terminal and two digital optical | |||
|
| ||
DIGITAL OUT terminal. |
| 110V | |
To reproduce the digital sound, use the digital connection in | 220V | ||
240V | 127V | ||
| 230 - |
| |
addition to the analog connection methods described on pages 7 |
|
| |
to 10. |
|
| |
English
Digital coaxial cable (supplied: 1 cable)
Digital optical cable (not supplied)
Turn off all components before making connections.
•When you connect other components, refer also to their manuals.
DIGITAL OUT
PCM/
STREAM
Connecting digital recording equipment to the DIGITAL OUT terminal enables you to perform
7Digital input terminals
220V 
110V
230 -
240V 127V
When the component has a digital coaxial output terminal, connect it to the 1(DVR/DVD) terminal, using a digital coaxial cable (supplied).
1(DVR/DVD) 2(DBS) 3(VCR)
DIGITAL IN
When the component has a digital optical output terminal, connect it to the 2(DBS) or 3(VCR) terminal, using a digital optical cable (not supplied).
Before connecting a digital optical cable, unplug the protective plug.
NOTES
•When shipped from the factory, the DIGITAL IN terminals have been set for use with the following components:
– 1(DVR/DVD): For DVD recorder or DVD player
– 2(DBS): | For DBS tuner |
– 3(VCR): | For VCR |
If you connect other components, change the digital input (DIGITAL IN) terminal setting correctly. See “Setting the digital input (DIGITAL IN)
•Select the digital input mode. See “Selecting the analog or digital input mode” on page 12.
•When you want to operate the connected component (except DBS tuner) using the AV COMPU LINK remote control system (see pages 40 and 41), connect them also as described on pages 7 to 10.
NOTE
The digital signal format transmitted through the DIGITAL OUT terminal is the same as that of the input signal. For example, when the DTS signals are input, the DTS signals are transmitted.
Connecting the power cord
When all the audio/video connections have been made, connect the AC power plug to the wall outlet. Make sure that the plugs are inserted firmly. The standby lamp lights in red.
CAUTIONS:
•Do not plug in before setting the VOLTAGE SELECTOR switch on the rear of the receiver and all connection procedures are complete.
•Do not touch the power cord with wet hands.
•Do not alter, twist or pull the power cord, or put anything heavy on it, which may cause fire, electric shock, or other accidents.
•If the cord is damaged, consult a dealer and have the power cord replaced with a new one.
NOTES
•Keep the power cord away from the connecting cables and the antenna. The power cord may cause noise or screen interference.
•The preset settings such as preset channels and sound adjustment may be erased in a few days in the following cases:
–When you unplug the power cord.
–When a power failure occurs.
•If the wall outlet does not match the AC plug, use the supplied AC plug adaptor.
11
