JVC RX-F31S manual Adjusting the subwoofer audio position

When operating the receiver

using the remote control, set

the mode selector to

“AUDIO/TV/VCR/DBS.”

Adjusting the subwoofer audio position

If the subwoofer sound is much reinforced for stereo sound compared to the sound reproduced with multi-channel, set the subwoofer audio position. The subwoofer output level is automatically decreased by the selected value when you are listening in stereo.

The AUDIO P. indicator lights up when this function is activated.

•Once you have made an adjustment, it is memorized for each source.

From the remote control ONLY:

Press SOUND, then press A.POSITION repeatedly.

•Each time you press A.POSITION, the subwoofer audio position level changes as follows:

AUDIO P. indicator

EQ C.TONE		VIRTUAL SB AUDIO P. BASS			TA NEWS INFO RDS TUNED ST AUTO MUTING SLEEP AUTO MODE
LPCM	L	C	R	PL	ATT
DOLBY D	S . WFR LFE			NEO : 6	HP
DTS AAC				DSP 3D	MHz
	LS	SB	RS
96 / 24				AUTO SR	kHz

–2 –4 –6

OFF (canceled)

The smaller the number becomes, the more the level decreases automatically when listening in stereo.

• If no adjustment is required, select “OFF” (initial setting).

NOTES

•The minimum subwoofer output level is –10 dB.

Ex.: When setting the subwoofer output level to “–8 (dB)” and the subwoofer audio position to “–4 (dB),” the subwoofer output level when listening in stereo will be –10 dB.

To adjust the subwoofer output level, see page 29.

•This function is not available when the Surround/DSP mode is activated or “DVD MULTI” is selected.

•After pressing SOUND, the numeric buttons work for sound adjustments. To use the numeric buttons to operate your target source, press the corresponding source selecting button before operation; otherwise, the remote control may not work as you intend.

14

Activating TV Direct

TV Direct enables you to use this receiver as an AV selector

while the receiver is turned off.

When TV Direct is activated, the pictures and sounds go from the video components such as DVD player to the TV through this receiver. Thus, you can use the video components and the TV as if they were connected directly.

•This function takes effect for the following sources—DVR/DVD, VCR, and DBS.

To activate (or deactivate) TV Direct, follow the procedure below:

1Press TV DIRECT.

All the indications disappear, then the source lamp of the current source lights in green.

2Turn on the video component and TV.

3Select the target video component. On the front panel:

Turn SOURCE SELECTOR until one of the source lamps—DVR/DVD, VCR, or DBS—lights in green.

From the remote control:

Press one of the source selecting buttons— DVR/DVD, VCR, or DBS.

The source lamp corresponding to the selected source lights in green.

To cancel TV Direct and turn off the receiver, press

STANDBY/ON on the front panel (or AUDIO on the remote

control).

The receiver is turned off and the standby lamp lights up.

To cancel TV Direct and turn on the receiver, press TV DIRECT again.

The receiver is turned on and the source lamp currently selected lights in red.

NOTES

•When TV Direct is activated, you cannot enjoy any of the sound effects the receiver produces, and cannot use the speakers connected to the receiver.

•When TV Direct is activated while “DVD MULTI,” “FM,” or “AM” is selected as the source, the source changes to the last selected source—“DVR/DVD,” “VCR,” or “DBS.”