Preparation (Step 1 Connection/Installation)
1.Preparations (Continued)
Connection to Alarm Input/Output Terminal
● Alarm Output Terminal
Connect this terminal to alarm devices such
Connect the alarm input/output terminals to
as an annunciator, indicator, lamp or buzzer.
Flathead
Screwdriver
3
1
|
| inches) |
| (1/8 | |
1 | 4mm | 2 |
| ||
Flathead | Alarm Signal | |
Screwdriver | Cable | |
external devices such as sensors and buzzers.
1 Loosen the screws on both edges of the terminal block using a flathead screwdriver, followed by dismantling it as shown in the left diagram.
2 Strip the coating of the alarm signal cable by about 4mm (1/8 inches) before inserting it into the terminal.
3 Turn the screw on the side to fasten the alarm signal cable.
*Connect the alarm terminal according to step 4 of “2 Installation.” (☞ Page 20)
(Alarm Output Equivalent Circuit)
|
| Alarm Device | |
|
| Connection | |
|
| Example | |
OUT |
| DC 12 V | |
IN | R | ||
Terminal | |||
Grounding |
| ||
Terminal |
|
| |
| GND |
| |
Output Requirements
•Equivalent to NPN open collector output (Set output logic using the controller)
•Allowed applied voltage: DC12V and below
•Allowed input current: 50 mA
•Momentary output: 1 to 5000ms (Set duration using the controller)
Caution
Connect the grounding terminal of
Note
Cable Specifications
Inserting the CF card
Insert CF card in the direction as indicated
● Alarm Input Terminal | Sensor | |
|
| |
| Connection | |
| Example (1) | |
DC12V |
| |
| VCC | |
|
| |
R |
| R |
| OUT | |
|
| |
12V | 1.2mA |
|
Grounding GND |
| |
Terminal |
|
|
(Alarm Input |
| Sensor |
Equivalent Circuit) |
| |
| Connection | |
|
| |
|
| Example (2) |
|
| Relay, switch, |
| OUT | etc. |
|
| |
50 m or shorter in length UL1007, UL1015 or equivalent AWG#22 to AWG#18 or equivalent
Caution
Due to external noise, the cable may not function properly even when the cable length is less than 50 m. In this case, use a shielded cable or take measures such as keeping the cable away from the noise source.
Connect this terminal to an infrared, door or metallic sensor, or to a manual switch.
Input Requirements
●
●The polarity of input detection can be selected via software
●Make/Break/Toggle (at least 250 ms)
●Circuit current at
●Voltage applied at high level: 12 V
Back |
Eject Button
in the diagram
•Press once if the eject button is protruding
•Insert the CF card all the way until you hear a "click" sound
* When removing the card, ensure that the power of the camera is turned off before pressing the eject button.
<List of Tested CF Cards>
•San Disk (Industrial) 128MB
GND 
18 |
|
|
| 19 |
