JVC VN-V686WPU Memo:, Memo:, Auto Pan Setting (continued), [Setting values : Low, Middle, High]

Settings and operation of Built-in Viewer

PTZ Controller Operation (continued)

Auto Pan Setting (continued)

AClick the [Auto Pan] tab to display the [Auto Pan] screen.

BSelect the [Mode] of the Auto Pan operation.

Right : This rotates the camera horizontally in the right direction from the [Start Position].

Left : This rotates the camera horizontally in the left direction from the [Start Position].

Return:Moves toward the [Return Position] from the [Start Position] in a clockwise direction, and moves to and fro between the [Start Position] and [Return Position].

Unless the restrictions below are applicable, you can specify any position as the Start Position and Return Position.

●When tilt angle is 90 degrees or higher: An error message appears when the tilt angle is set to 90 degrees or higher.

●Electronic zoom area:

When electronic zoom is used, the maximum optical zoom ratio is specified.

Memo:

● If the zoom ratios of the [Start Position] and

[Return Position] are different, Zoom and Pan/Tilt movements may not be uniform.

CSelect the Auto Pan operation speed.

[Setting values : Low, Middle, High]

DSelect the [Start Position] and [Return Position] (only during AReturnB) of the operation.

Operate the camera manually, decide on a position and click [Apply] to register.

Click [Go To] to move the camera to the registered position.

Memo:

● For details on the manual operation, see [Operation] (A Page 106).

EClick [Apply] to complete the Auto Pan setting.

114