Connection/Installation

Mounting the Camera (continued)

Mounting the Camera1 Mounting the fall prevention wire

●Mount the fall prevention wire of the camera to the fall prevention wire anchor bolt that was installed earlier.

●Secure the fall prevention wire tightly with a nut and washer.

2 Pull out the cables (from the wall) from the cable connection hole.3 Mount the camera to the wall

●Mount the camera to the camera anchor bolts that were installed earlier.

●Secure the camera tightly with a nut and washer.

3 Washer

Nut

1

Fall Prevention

Wire2

Note：

●This product weighs approximately 5.5kg. When installing, pay extra attention to the fall.

●For your safety, hold the arm section during installation.

●After installing, paint the nuts and washers to prevent corrosion.

Memo:

●To remove the camera, follow the reverse procedures.

Cable Connection1 LAN Cable Connection (A Page 22)

AUse the provided RJ-45 conversion connector and connect the LAN cable.

BWind the connector section with waterproof tape (adhesive) and push the cable into the arm of the camera.

Arm

 

A

 

RJ-45

B

conversion

connector

Wind the

(provided)

 

waterproof tape

 

(adhesive)

 

2 Connecting the power cable (A Page 20)

Connect the power cable and wind the waterproof tape (adhesive).

After connecting, push the cable into the arm of the camera.

Arm

Wind the waterproof tape (adhesive)

18