JVC VN-V686WPU Memo:, Note：, F Auto Flip, [Setting values : Off, Digital Flip, Mode1, Mode2, Mode3]

F Auto Flip	Set this item when shooting objects that pass right under the camera.
	Otherwise, following operations are necessary to shoot objects that pass
	right under the camera.
	ATurn the camera to face down
	BRotate the camera 180  horizontally
	CTurn the camera to face up
	You can use the [Auto Flip] function to perform the above operations
	automatically.
	Off : Auto Flip function does not activate.
	Digital Flip
	: The top/bottom and left/right of the image flips when tilt position passed
	the angle of 135 degrees.
	Mode1: When the camera faces bottom, it rotates 180  horizontally and stops.
	In this case, the operating direction of the camera is the same as that of
	the Pan/Tilt operation.
	Mode2: When the camera faces bottom, it rotates 180  horizontally and the
	operating direction of the camera is opposite that of the Tilt operation.
	Select this mode if you wish to operate continuously. Once operation
	stops, the direction will return to normal.
	Mode3: When the camera faces bottom, it rotates 180  horizontally and the
	operating direction of the camera is opposite that of the Tilt operation.
	However, the operating direction will return to normal 10 seconds after
	the operation has stopped.
	[Setting values : Off, Digital Flip, Mode1, Mode2, Mode3]

Memo:

●[Intelligent Tracking] is disabled when ADigital FlipB is selected. (A Page 55)

●Settings for [Preset Position Speed] are reflected in the rotation speed when images are flipped using AMode1B, AMode2B, AMode3B. To flip images in high speed using AMode1B, AMode2B, AMode3B, set the [Speed] in [Preset Position Speed] to A4B.

Note：

●When [Auto Flip] is set to other than AOffB, the camera can be moved to areas outside the pan limit with the Tilt operation. When ADigital FlipB is set, use the Tilt operation to flip and return to the pan limit area again. When AMode1B, AMode2B or AMode3B is set and the camera is moved to inside of the pan limit with Pan operation, it will stop at the pan limit position.

59