JVC VN-V686WPU Setting Up the Wall, Setting Up the Camera, 1 Remove the dome cover, 1 Make holes in the wall, 4 Pull the cables from the hole in the wall

Connection/Installation

Mounting the Camera

Setting Up the Wall

Be sure to put on protective glasses to protect your eyes from falling objects when mounting the camera.

1 Make holes in the wall

Make holes (R 45 mm) for the connecting cables to pass through.

Note：

●Check the strength of the wall. A less firm wall may cause the unit to fall.

2 Install the anchor bolts for mounting the camera

Install 4 anchor bolts (M8  35 mm and above) to mount the camera.

3 Install the anchor bolt for mounting the fall prevention wire

Install the anchor bolt (M8  35 mm and above) to mount the fall prevention wire 30 mm below the center of the upper two anchor bolts that are used to mount the camera.

152
126
63
12	30
	176	213
60
	20

3

Anchor bolt to		2
mount the fall		Anchor bolts to
prevention wire	1
		mount the camera

4 Pull the cables from the hole in the wall

Pull the power cable, LAN cable and alarm signal cable from the wall.

LAN Cable

Power cable

Alarm signal cable

Setting Up the Camera1 Remove the dome cover

Loosen the screws (x4) and remove the dome cover from the camera.

Dome Cover

16