JVC VN-V686WPU 4 Remove the cable connection cap, 3 Mount the dome cover to the camera, 5 Pull out the cables from the cable connection hole

2 Remove the cushioning material, lens cap and tape used during transporting

When installing the heater at an unrequired location, turn off the switch of the heater.

Tape

Cushioning material

Heater power switch

OFF

Lens cap

3 Mount the dome cover to the camera

Use the screws (x4) to mount the dome cover to the camera. As a guide, install three claws of the dome cover and the central mark. Install such that the central mark appears above the JVC mark of the camera.

Position aligning claws (x3)

Face front

(towards direction of the JVC mark)

Note：

●Check that there is no dirt or dust inside the dome cover before mounting.

●When installing on a rainy day, ensure that raindrops do not enter the interior.

●When mounting the dome cover, temporarily secure the 4 screws and then tighten.

●As a guide, tighten the screws to 0.5 N•m to 1 N•m (5 kgf•cm to 10 kgf•cm). If the tightening is loose, the dome cover may fog due to water seepage.

4 Remove the cable connection cap

Remove the cap on the arm of the camera.

5 Pull out the cables from the cable connection hole

Pull out the cables (except the fall prevention wire) of the camera from the cable connection hole.

Cable connection cap

4

5

17