Kenmore 385.16677 owner manual Changing Needle, Raising or Lowering the Presser Foot

Changing Needle

Turn off the power switch and unplug the machine. Raise the needle to its highest position.

Then loosen the left or right needle clamp screw for the needle you are going to remove.

(_ Needle clamp screw on the left (_ Needle clamp screw on the right

* Use HA-1SP#14 Needle or #11.

To attach the needle on the right "

Insert a new needle into the needle clamp with the flat side to the back until the top of the needle touches the stopper pin, then tighten the needle

clamp screw on the right.

To attach		the	needle		on the left "
Insert a new needle into the needle
flat side to the back until the to_
touches		the edge		of the		needle _	_:_ i{_	h#
needle	clamp		screw		on the left:		.......
* When		the	needles		are	set _	t!Y, the left
needle		is	high_[_he			rig_	_:
* Use HA-1S_					I'4	_i_or
(]_)Needl_			i	p		.......
(_) Needle
(_	Needle			_ _pin		....
@	Edge of					......
(_	Needle					......

(_ Flat side to the back

* Do not use any needle which is bent or blunt.

Raising or Lowering the Presser Foot

By raising or lowering the presser foot lifter, the presser foot goes up or down.

*While in operation, keep the presser foot lowered except when threading the machine or test running without threads.

Thread tension will be released when the presser foot lifter is raised.

(_ Presser foot

(_ Presser foot lifter

//

J

12