Kenmore 385.16677 owner manual Lowerknifeiii to, Adjustment Cutting Width

Adjustment	of Cutting	Width
When cutting	width is too	narrow or too wide against	L
seam width, adjust it as follows.

1.Turn off the power switch and unplug the machine.

2.Open the looper cover and side cover.

3.Set the upper knife to down position

4.Turn the cutting width adjusting dial to get desired position of lower knife.

(_ Cutting width adjusting dial
	Lower knife
(_	Standard setting				....
* The cutting width of this mod
approximately			3.0	to 5.0 mr
needle		position	depending		:_ your	sewin_	:
needs		or the fabric		......being	....
(The cutting						to g	.............
same
When cuttin_:wiath is too na_ro						......
Turn	cutting				i : Iockwise	(A).

Lowerknifeiii : : to

When cutting width is too wide.

Turn the cutting width adjusting dial counterclockwise

(a).

Lower knife will move to left.

5.Set the upper knife to up position.

6.Close the looper cover and side cover.

/./

//

/JJ(_

J

20