INSTALLING THE COVER OVER THE SPEAKER/ MICROPHONE JACKS
Note: When installing the speaker/ microphone jack cover, you must remove the battery pack from the rear of the transceiver.
If you are not using a speaker/ microphone, install the cover over the speaker/ microphone jacks by sliding the cover’s tab into the slot on the side of the transceiver until it snaps in place.
Note: To keep the transceiver water resistant, you must cover the speaker/ microphone jacks with the supplied cover.
INSTALLING THE (OPTIONAL) SPEAKER/ MICROPHONE
Note: When installing the optional speaker/ microphone and its locking bracket, you must remove the battery pack from the rear of the transceiver.
1Insert the speaker/
microphone plugs into the speaker/ microphone jacks.
2 Attach the locking bracket using the supplied screw.
Note: To lift the locking bracket after it has been installed, use a piece of hardened plastic or metal, such as a small screwdriver. Lift the bracket by its tab, beside the screwhole, taking care not to damage the bracket.
10
