SCAN RESUME METHODS

Before using Scans other than Visual Scan, it’s necessary to decide under what condition you want your transceiver to continue scanning after detecting and stopping for a signal. You can choose Time-Operated mode or Carrier-Operated mode. The default is Time-Operated mode.

•Time-Operated mode

Your transceiver stops scanning after detecting a signal, remains there for approximately 5 seconds, and then continues to scan even if the signal is still present.

•Carrier-Operated mode

Your transceiver stops scanning after detecting a signal and remains on the same frequency until the signal drops out. There is a 2 second delay between signal drop-out and scan resumption to allow time for any responding stations to begin transmitting.

Note:

◆Turning the Tuning control clockwise, or pressing Mic [UP] after a signal that has stopped Scan drops out, causes scanning to resume immediately upward.

◆Turning the Tuning control counterclockwise, or pressing Mic [DWN] after a signal that has stopped Scan drops out, causes scanning to resume immediately downward.

■Selecting Scan Resume Method

1 Select the desired band.

2 Press [MNU] to enter Menu mode.

3 Select Menu No. 8 (Scan Resume).

CALL

PWR

VOL SQL

4Press [SET] to toggle Time-Operated or Carrier-Operated.

5Press [MNU] again to exit Menu mode.

1

2

3

4

5

6

7 8

9

10

11

12

13

14

15

16

17

18

19

20 21

43