■Using Visual Scan

1

1

Select the desired band.

 

2

2

Turn the Tuning control, or press Mic [UP]/[DWN],

 

3

 

to select the operating frequency.

4

 

• This frequency will also be used as the center

 

 

 

 

frequency.

 

 

 

 

 

5

3

Press [F], [VISUAL] to start Visual Scan.

6

 

• To halt Scan, press [PAUSE]. "P" appears.

7

 

 

 

 

Press [PAUSE] again to resume.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

8

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

9

10

11

4To change the operating frequency, turn the Tuning

12control or press Mic [UP]/[DWN].

13 • The displayed frequency changes and the cursor

14

moves.

 

•Press [SET] to use the changed operating frequency

15as the center frequency.

16• Press [RESET] to restore the previous operating

Note:

◆If you start Visual Scan in Memory Recall mode, the memory channel frequencies will be scanned.

◆If you start Visual Scan after recalling the Call channel, the call channel frequency will be used as the center frequency.

◆Visual Scan stops while transmitting.

◆Starting Visual Scan switches Automatic Band Change OFF.

◆If you start Visual Scan in one of the following conditions, you cannot receive in the current operating frequency. To use this frequency, press [PAUSE] to halt Scan.

•Memory Recall or Call Channel mode

•The VHF band, VFO mode, and a frequency in the range 118 MHz to 136 MHz were selected.

◆Depending on conditions, Visual Scan and the conventional S-meter may indicate different signal strength levels.

17

frequency.

5 To quit Visual Scan, press [OFF].

18

19

20

21

42