3Connect the other end of the connectorized front panel cable to the One Touch panel.

•The cut-away corners of the connector should be inserted first into the space such that the corners mate with the positioning tab.

Positioning tab

Cut-away corner

Bracket

Screw

4Install the front panel onto the One Touch panel by first positioning the left rear edge of the front panel, then pressing the right side of the front panel firmly against the One Touch panel.

• When the release switch clicks, the front panel is secured.

5Assemble the mounting brackets, and install the front

panel on the appropriate place in the vehicle.

1

• When installing the front panel in the vehicle, use a

2

cushion under the bracket to protect the vehicle.

 

• Adjust the angle of the front panel before firmly tightening

3

the two Allen screws.

 

4

• Route the cable so neither the connections nor the cable

5

are under stress.

 

 

Self-tapping screw

6

 

(3 mm x 14 mm)

7

 

14 mm

One Touch panel

8

 

 

 

 

Flat washer

9

 

Allen screw

10

 

Flat washer

11

Cushion

6 mm

12

 

13

 

 

Allen

 

14

 

 

wrench

Self-tapping screw

15

Allen screw

(3 mm x 6 mm)

 

Cushion

16

 

 

 

 

Onto the

17

 

 

 

appropriate place

18

 

in the vehicle

19

 

 

Note: Consider the safety of driver and passengers when deciding

20

where to install the front panel. Tighten all screws firmly.

 

 

 

21

85