Problem | Probable Cause | Corrective Action | Page | |
Ref. | ||||
|
|
| ||
|
|
|
| |
The way the transceiver | The electrical contacts on the front | Clean the electrical contacts on both the front | — | |
functions or displays | panel and main unit were soiled. | panel and the main unit using a clean damp |
| |
information is strange. |
| cloth. |
| |
|
|
|
| |
The display is too dim, | The supply voltage is too low. | The supply voltage requirement is | 3, 4 | |
even though you selected |
| 13.8 V DC ± 15% (11.7 V to 15.8 V DC). |
| |
a high dimmer level. |
| If the input voltage is outside this range, |
| |
|
| recharge your battery, adjust your regulated |
| |
|
| power supply, and/or check all power cable |
| |
|
| connections. |
| |
|
|
|
| |
The frequency cannot be | Memory Recall or the Call channel | Press [VFO]. | 8 | |
selected by turning the | was selected. |
|
| |
Tuning control or by |
|
|
| |
pressing Mic [UP]/[DWN]. |
|
|
| |
|
|
|
| |
Most buttons/keys and the | 1 One of the Lock functions is ON. | 1 Unlock all of the Lock functions. | 67 | |
Tuning control do not | 2 The front panel was not | 2 Separate the front panel from the main unit | 84 | |
function. | ||||
connected securely to the main | by using the release switch on the rear of |
| ||
|
| |||
| unit of the transceiver. | the front panel, then lock the front panel |
| |
|
| securely to the main unit by using the same |
| |
|
| switch. |
| |
|
|
|
| |
Memory channels cannot | 1 No data has been stored in any | 1 Store data in some memory channels. | 30 | |
be selected by turning the | memory channels, or stored data |
|
| |
Tuning control or by | was erased by Full Reset. |
|
| |
pressing Mic [UP]/[DWN] | 2 The Call channel was selected. | 2 Press [MR] to switch to Memory Recall. | 31 | |
when using Memory | ||||
|
|
| ||
Recall. |
|
|
| |
|
|
|
| |
|
| Continued | ||
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
89